19 Item(s)

The plastic truss bar bracket and bolt that is used to connect a pair of truss bars together.
The dome shaped cap that fits on to the top of the upper peak pole section.
The lower bracket in the peak pole section that the peak pole and four truss bars connect into.
Triangular shaped metal foot plate with three drilled holes
This bracket is designed to fit any corner leg in the Pro Expo range. For middle legs please see Middle Leg Top Bracket.
The bracket that slides up and down the middle leg of a 10' x 20' or 13' x 23' when the frame is expanded and collapsed.
This pull pin bracket is used to adjust the leg height position. The same bracket fits any of the four sides.
A bracket that three truss bars connect into towards the top of the frame.
The upper bracket in the peak pole section that the upper peal pole fits through and four truss bars connect into.
The bracket that sits on the top of the middle leg of a 10' x 20' or 13' x 23', with three truss bars connecting into it.
This bracket is the one that slides up and down the leg as you expand and collapse the frame.
A bracket that three truss bars connect into towards the bottom of the frame.
A single truss bar that fits our 10' x 10', 10' x 15' and 10' x 20' frames.
The lower half of the Aluminum peak pole section that supports the Canopy.
The upper half of the Aluminum peak pole section that supports the Canopy.
A single truss bar for 13x13, 13x20 and 13x26 frames
This part is the inner leg, referred to as the Lower Leg Section. This lower leg comes complete with a metal foot plate, and slides into the upper leg section without the need for any further parts.

Available in Sliver, Black, Red, Blue and Green in Pro Expo 10ft ONLY. All other bars available in Silver.

Sold in pairs, with four brackets to connect bars to your frame.

The Upper Leg Section is the longer outer leg that the lower leg slides into. This part is not supplied with either the top corner or corner slider bracket, but does come complete with Velcro pad in situ.